Optimized drilling movement
Large 30 kW servo drive for extreme acceleration rates
Using synchronized servo drives with ball screws for each movement as well as a large 30 kW servo drive for the drilling spindle results in extreme acceleration rates and high velocities.
Maximum feed rate towards material
When the operator stores a new tool in the tool changer the length of the tool is automatically measured and saved. The top side of the plate is constantly measured. These two measurements allow the drill to move with a maximum feed rate towards the material.
Just before the drill touches the material the software adjusts the speed to the specified feed rate for the drill type and material combination for optimal drilling results.
When multiple holes are drilled with the same diameter the drill stays as close as possible to the material and does not retract after each hole. The elimination of idle movement ensures a capacity increase of 20% in a fully nested plate.
Holes with the same diameter are automatically clustered to eliminate redundant tool changes.